Fitting Guides

Step 1
Step 1

Flip head strap forward and place the mask on the patient's face. Pinch the OmniClip™, slide up or down to position on patient's face

Step 2
Step 2

Flip head strap back over patient's head, bring tabs forward on "top" head strap and adjust equally to proper fit

Step 3
Step 3

Attach bottom two clips and repeat Step #2

Step 4
Step 4

Connect Circuit, turn on flow

Step 5
Step 5

Adjust the OmniClip™ in and out, as well as the headstraps and mask for the best fit. Do not over tighten the head strap

Step 1
Step 1

Flip Head Strap forward over front of BiTrac MaxShield

Step 2
Step 2

Flip head strap back over patient's head, and place BiTrac MaxShield so the flap seal is below the lower lip

Step 3
Step 3

Adjust the Head Strap on crown of patient's head while holding BiTrac MaxShield in place

Step 4
Step 4

Attach both bottom clips of the Head Strap to BiTrac MaxShield

Step 5
Step 5

Adjust Head Strap to fit: Do NOT Overtighten Head Straps

Step 6
Step 6

Connect Circuit, turn on flow, re-adjust Head Straps as needed